
Full-body and facial light therapy
SAR 4,900
Six clinically selected wavelengths across seventy emitters. Built for a twenty-minute daily session on the face, and sized to treat the body when you want it to.
First release, 2026. Designed in Saudi Arabia. Ships worldwide on AC 100–240 V, so no adapter is required.
For the face
Fine lines are a structural change, not a surface one. As collagen and elastin production slows, the dermis loses density and the skin above it creases and holds the crease.
Topicals work above that layer. Red light at 630 and 660 nanometres passes into it, and is absorbed by the fibroblasts responsible for producing collagen in the first place. Given more available energy, they produce more of it.
The change is gradual and cumulative, which is the honest version. Most published protocols run three to five sessions a week over eight to twelve weeks before the difference is clearly visible.
Engineering
01
Fewer, brighter emitters produce a hot centre and a dim edge. Seventy lower-driven LEDs spread the same delivered energy across the whole treatment area, which keeps the dose even across the face and lets each emitter run well below its thermal limit. Running cool is the single largest factor in how long an LED holds its rated output.
02
A bare LED throws light in a wide, uncontrolled cone. Most of it never reaches the skin, and what does arrives at an angle that reduces absorption. A 30° lens holds the beam where it is aimed, so the figure measured at the panel surface is close to the figure delivered to the dermis.
03
Plastic housings insulate. Heat accumulates behind the array, output drifts downward during a session, and the emitters age faster than their rating suggests. Cold-rolled SPCC steel conducts that heat into the body of the panel and away, which is why the output at minute twenty matches the output at minute one.
04
A panel used for twenty minutes a day sits close to the body for thousands of hours across its life. Driver placement and shielding were treated as a design constraint from the beginning rather than a figure to measure afterwards. The result is no detectable electromagnetic emission at treatment distance.
Wavelength selection
630nm
Visible red
The band most closely associated with collagen activity, skin tone and surface texture.
660nm
Deep red
Reaches into the dermis where fibroblasts sit, while remaining where cellular absorption peaks.
810nm
Near-infrared
The deepest practical penetration for soft tissue. Central to the recovery literature.
850nm
Near-infrared
Carries into joints and denser tissue where shorter wavelengths cannot reach.
940nm
Far-infrared
Extends the delivered spectrum and contributes gentle thermal effect at depth.
1060nm
Far-infrared
The upper boundary of the panel. Broadens coverage rather than concentrating it.
Specifications
Red light therapy is a wellness practice, not a medical treatment. minara is not intended to diagnose, treat or cure any condition. Results vary between individuals. Speak with a healthcare professional about your own circumstances.
That is roughly one percent of the panel’s rated life. It is built for the long version of this, not the trial.